VOLUME, DEPTH, PRESENCE knobs.

POWER MAX/MIN, MODERN/VINTAGE, STANDBY, MAINS switches.

TUBES: 2 X 6P14P / EL 84, 12AX7/ECC83

OUTPUT POWER 10 W.

8 / 16 OHM

Fantastic transparent bold and wide touchy sound. All you need for finishing your mixes.

pentode saturator: knobs: GAIN,VOLUME, MIX.

tape machine: knobs: INPUT, DINAMIC (dymanic bias control), BIAS, MIX. switch: 30/15(treble control)

stereo: knob: WIDE.

TUBES: EF86/6J32P – 2PCS.

All modules use sound transformers.

SYMETRIC INPUTS AND OUTPUTS, TRUE COLD BYPASS.

REC AMP SPECIAL is tube amp for pro guitar recording and playing. Just add it to your sound chain for pleying, silent oir load recording and anjoy!

knobs: VOLUME, DEPTH, PRESENCE

tubes: 12AX7, 2 x EL84

power: 10W max. per 8 or16 Ohm

REACTIVE LOAD, DIRECT OUT, ANALOG SPEAK SIM OUT.

This mono device is specially designed to give your instruments and voice nice TRUE tube saturation and distortion to enhance them in the mix.

This tube mono parametric EQ has nice saturation and distortion. One 12AX7 tube is used for amplification and distortion. The PULL-PUSH (PP) stage gives the best harmonic balance and dynamic response in distortion mode. Other 12AX7 tubes used on the bands (one triode per band) combined with high voltage FETs to improve EQ performance. So the semiconductors give the clarity and low impedance needed for the band’s schematics and tubes give saturation (non-linearity that improves the sound).

The best choice for making “dirty drums” or process you bass, vocal and other mono instruments.

knobs: GAIN (tube saturation and distortion), LFP(lowest frequency pass through the tube and EQ), bass GAIN, RESONANCE, FREQUENCY, low mid GAIN, RESONANCE, FREQUENCY, high mid GAIN, RESONANCE, FREQUENCY,, treble GAIN, RESONANCE, FREQUENCY, HPF (output highest frequency set), VOLUME.

tubes: 3 x 12AX7

SYMMERIC INPUTds and OUTPUTs (XLR and TRS)

Knobs: VOLUME, DEPTH, PRESENCE.

Switches:

for 12AX7 tube: BOLD & FAT.

for EL84 & 6V6: TRIODE/PENTODE(TETRODE) & EL84 SE / EL84+6V6 PP / 6V6 SE.

for speaker simulator: A/B/C (mic posicions)

for amp load: SPEAKER / DUMMY (reactive load)

Speaker sim jack connection: TIP – SPEAKERSIM out, RING – DIRECT out, SLEEVE – ground.

speaker output: 8 &16 Ohm

tubes: 12AX7, EL84, 6V6

Output power: SE modes 5W max, PP mode 10W max.

Specially designed home low volume head with BIG sound!

All channels knob sets: GAIN, BASS, MIDDLE, TREBLE, VOLUME.

CH1 bright SWITCH: BASS BOOST+BRIGHT(LOW POS) / NO

RMAL/ BRIGHT

DEPTH, PRESENCE, MASTER.

FX LOOP switch,

2 buttons FOOTSWITCH.

Tubes: 3 X 12AX7/ECC83, 1 x 6P14P (EL84)

Output power 5W max.

8 & 16Ohm outputs.

This amp is designed especially for overdriven output tubes sound lover.

knobs: VOLUME, DEPTH, PRESENCE.

switch: MODERN/VINTAGE.

tubes: 2 x 12AX7, 2 x 6P3S (6L6 / EL34)optional

output power 20W per 8 / 16 Ohm

knobs: VOLUME, PRESENCE, DEPTH.

power: 5W / 1W

Sound character: MODERN (vintage could be ordered also)

Tubes: 12AX7, 2 x 6P6S (russian marked 6V6)

speaker: 8 & 16Ohm

knobs: VOLUME, DEPTH, PRESENCE.

switches: mode: MODERN(UP)/VINTAGE1/VINTAGE2.

power mode: 20W / 5W.

tubes: 12AX7, 2pcs x 6P3S-E(russian military 6L6)

speaker: 4, 8, 16 Ohm.

knobs: VOLUME, DEPTH, PRESENCE.

switches: recout: DIRECT/SPEAKERSIM, mode: MODERN/VINTAGE1/VINTAGE2.

tubes: 2 x 12AX7, 4 x EL84.

Output power 10W + 10W.

You can play with a cabinet or “silent”with internal reactive load and recording at the same time!

Reactuve load is activeted if no speacer jack connected.